3/30/2021 0 Comments Hh Obd Setup Manual
Also, on the VSGS Models, Freeze Protect Mode overrides Priming Mode, and All pumps will be on in Freeze Protect Mode.The spa topside panel messages include common diagnostic messages, operational messages, and various other messages such as reminders.
Hh Obd Setup Install Spa RelatedFailure to properly service or install spa related components can result in serious injury or death.DO NOT remove the protective covers from any electrical enclosure, or attempt to service any related electrical device, unless you are a qualified electrician or service professional. There may be conditions that exist in which the spa control system will be unable to detect these conditions. As a responsible adult, always check the topside control panel display for errors and verify safe water temperature before using a spa, and before allowing children to use a spa. Between Filter Cycles, while in the Economy or Sleep Heating Modes, the Pump has not turned ON and the Last Water Temperature is not Current. To read the Current Water Temperature, either Change to Standard Heating Mode or turn On the Heating Related Pump, and wait at least 2 Minutes. Priming Mode has been Exited and the Pump has Not yet run for 1 or 2 Minutes (depending on Model) to Sample Actual Water Temperature. With the Heat Related Pump Running, wait at Least 2 Minutes for the Correct Actual Water Temperature to be Displayed. This Error Message indicates that the Dip Switch Numbers Displayed or the Configuration Setting Values Displayed on the Topside Panel, following the CFE Message, are in Conflict with each other. Contact your Dealer or Service Organization to check the Switch Numbers or Setting Values Displayed, and Correct as Necessary to Match the Equipment in the Spa System, or Continue for a Detailed Test Procedure. Turn OFF the Power to the System and Turn it back ON again to put System into Priming Mode. Press any Cool, Warm, or Temp Button to Exit Priming Mode. After about 45 Seconds, Check for Error Messages on the Topside Panel Display. If there is Now an Error Message, select Message Other than CFEor CONFIG ERROR below or contact your Dealer or Service Organization. No Error Messages: The CFE or CONFIG ERROR Configuration Error Appears to have been Corrected or is Intermittent. If the Error Repeats, Retest the CFE or CONFIG ERROR Configuration Error or Call Balboa Technical Service for Assistance. ![]() The idea is that, if anything in the file changes, the checksum will change and Result in a CrC Error. This indicates a Problem with the Firmware (Operation Program), or the System is Operating on Unreleased Firmware (Sample or Prototype System). Try Turning the Power OFF and back ON again, or contact your Dealer or Service Organization. If there is Now an Error Message, select Message Other than CrC or CHKSUM FAIL below. If there is Now a Message Other than a CrC or CHKSUM FAIL Error Message, that Message will Now have to be Diagnosed. If there is Now a CrC or CHKSUM FAIL Error Message, contact your Dealer or Service Organization. Note: On the VSGS Model, the Circ Pump will be on, and on some ELGL Models, a continuous filtration pump turns on automatically.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |